Filter
Top Products
PAGE 42 — PS7060 MULTIQUIP SAW • OPERATION MANUAL — REV. #2 (06/02/08)
PS7060 MULTIQUIP SAW — MAINTENANCE
Oil And Fuel Lines
■
Check the oil and fuel lines and connections regularly for
leaks or damage. Repair or replace as necessary.
Figure 43. Fuel Filter Removal
Fuel Filter (500 Hours)
■
Replace the engine fuel filter (Figure 43) every 500 hours.
Refer to your engine manual for specific details to perform
this operation.
See the engine manual supplied with your
machine for appropriate engine maintenance
schedule and troubleshooting guide for
problems.
Engine Tune-Up
■
See your engine manual for specific information on tuning
up your engine.
At the front of the book (Page 9) there is a “Daily Pre-Operation
Checklist”. Make copies of this checklist and use it on a daily
basis.
Disconnect negative (ground) battery cable and secure away
before attempting any service or maintenance on the saw.
Lubrication
This saw has 4 grease fittings on the front axle assembly.
Grease these fittings every 125 hours of operation with a premium
grade waterproof E.P. (extreme pressure) grease.
Prevent Crush Injury!
Ensure the saw is securely placed
on blocks before servicing
lubrication points.
WARNINGWARNING
WARNINGWARNING
WARNING
1. Front Axle Pivot Bearing
2. Hydraulic Lift Cylinder End
Figure 44. Grease Fittings
This saw has many service-saving features, including fully
enclosed oil bath lubricated Blade Shaft bearings that require
no daily lubrication.
1