Filter
Top Products
13 Interruption and Restart of Automatic Operation
102
if machining is started in INTD state of automatic mode and START button is pressed, control
registers STOP state and message
RESTORE MODAL FUNCTIONS? Y
is displayed (Y=yes). By pressing <SHIFT> key question
RESTORE MODAL FUNCTIONS? N
is asked (N=no). The messages can be switched over by the use of <SHIFT> key . If the
START button is pressed, it restores the state before suspension according to the
message (Y) or not (N). The message is canceled with the help of the RESET key and
INTD state remains.
Modal information restated or not restated:
– modal G codes,
– value F,
– compensation code: T__nn,
– modal parameters of canned cycles (start level, R level ect).
After restart has been made from INTD state the work zero point offsets and tool compen-
sation values altered always taken into consideration.