Filter
Top Products
14.3 Listing of Global Messages
Error
Code
Message Description
Canceling and Re-
pairing Method
138
3100
3101
BLOCK NOT FOUND If the block searched for is not found and
the end of program is reached (M2, M30
or %).
The message is can-
celed by RESET
key.
3102
INCORRECT POSITION
G12.1
If polar coordinate interpolation is on
(G12.1) and
the position of the 1st axis is 0, or
the position of the 2nd axis is not 0.
The message is can-
celed by RESET
key.
3103
OUT OF RANGE This message is displayed, if the tool off-
set sensor signal does not come in within
the distance which is specified at parame-
ter 8002 ALADIST while executing tool
length measurement block G37.
The message is can-
celed by RESET
key.
3104
COMPENSTN VALUE TOO
HIGH
If the modified wear offset value is out of
the range of +/– 16000 increments when
executing cycle G36, G37.
The message is can-
celed by RESET
key.
3105
POCKET NUMBER IS TOO
HIGH
If there are more than 10 concave pockets
in the profile when executing the turning
cycles G71, G72 in case of lathe controls.
The message is can-
celed by RESET
key.
3106
3107
3108
3109
3110
3111
3112
3113
3114
3115
3116
3116
3118
3119
3120
3121
3122