Filter
Top Products
14.3 Listing of Global Messages
Error
Code
Message Description
Canceling and Re-
pairing Method
139
3123
3124
3125
3126
3127
3500
PROGRAM EDITED This message is displayed, if program se-
lected for automatic execution is edited in
automatic mode, or
if program selected for manual data input
execution is edited in MDI mode,
meanwhile START is pressed.
The message is can-
celed by RESET
key.
The program can be
started if the EDIT
screen is closed after
terminating editing.
3502
BAD BAUD RATE VALUE If not standard baud rate value or a baud
rate that cannot be interpreted by control
is set at parameter 2002 BAUD RATE. It
is displayed in DNC mode. The values
interpreted by the control are listed in the
description of parameters.
The message is can-
celed by RESET
key.
3503
SERIAL BUFFER FULL If the serial buffer has been overrun in the
course of DNC machining.
The message is can-
celed by RESET
key.
Data transfer must be
restarted.
3504
TOOL PLACE TABLE BAD If NC finds the check sum of the tool pot
table false.
The message is can-
celed by RESET
key.
Tool pot table must
be reorganized.
3505
NOT EXISTING
PROGRAM
If a program had been selected for auto-
matic or MDI execution, than the program
was deleted and without selecting a new
program START is pressed in automatic
or MDI mode.
The message is can-
celed by RESET
key.
3507
OVERWRITE (Y/N) If the program being executed loads pro-
gram to the control memory by means of
command DPRNT, with the number of
which a program has already been regis-
tered in the directory.
If the old program is
to be overwritten key
Y must be pressed,
otherwise key N or
RESET.