Filter
Top Products
14.3 Listing of Global Messages
Error
Code
Message Description
Canceling and Re-
pairing Method
132
3029
GROUP NUMBER IS TOO
HIGH
If in block G10 L3 (filling up life time ta-
ble) the number of tool groups exceeds the
maximum value registered on parameter
1181 GROUPNUM.
The message is can-
celed by RESET
key.
3030
DEFINITION ERROR T If tool call is being programmed (address
T) and value T is greater than 9999, or is
negative.
The message is can-
celed by RESET
key.
3031
ALL TOOL LIVES ARE
OVER
If, in case of tool selection, all tool lives
within the group referred to (address T)
has expired.
The message is can-
celed by RESET
key.
3032
CONFLICTING M CODES If conflicting M codes have been program-
med.
The message is can-
celed by RESET
key.
3033
DEFINITION ERROR M If M function is being programmed and
the value, written under the address, is
greater than 999 or is negative.
The message is can-
celed by RESET
key.
3034
DEFINITION ERROR A,B,C If address A, B or C is specified as func-
tion and its value is greater than 65000.
The message is can-
celed by RESET
key.
3035
DEFINITION ERROR P If dwell is being programmed (G4 or
canned cycle) and value P is greater than
105, or is negative,
if in block G4 address P is not filled out ,
if in block G5.1 or G10 it is filled out
incorrectly.
The message is can-
celed by RESET
key.
3036
G39 CODE IN G40 If block G39 is programmed in state G40
or in 3D tool radius compensation mode.
The message is can-
celed by RESET
key.
3037
G39 NOT IN G1,G2,G3 If block G39 is programmed and the
previous block is not G1, G2 or G3.
The message is can-
celed by RESET
key.
3038
DEFINITION ERROR Q In case of intersection calculation has not
been specified on address Q which inter-
section is to be calculated,
in G70, G71, G72, G73 turning cycles the
end block number of the profile has not
been specified,
in the G76 multiple thread cutting cycle
the first cut specified on Q is not
interpretable.
The message is can-
celed by RESET
key.
3039
G38 CODE IN G40 If a vector hold block (G38) is
programmed in state G40 or in 3D tool
radius compensation mode.
The message is can-
celed by RESET
key.