Filter
Top Products
MATWorX 32 User’s Guide
Page 32 NDA-24215 Revision 1.0
Getting Started
◆
Have you entered configuration information for
your PBX?
Yes - Go to the next bullet item.
No - Run the PBX Configuration Wizard to
establish the proper communication settings
between your computer and the PBX.
I don’t understand the question - Once
the hardware link is established, configuration
information is necessary for the PC to connect
to the PBX. For example, to dial the PBX, your
PC must know the PBX's phone number. If you
have not entered this data, you must do so by
using the PBX Configuration Wizard.
◆
Have you run the PBX Configuration Wizard again
since the connection failed?
Yes - Go to the next bullet item.
No - Run the PBX Configuration Wizard to
detect any connection changes and re-establish
the proper communication settings between
your computer and the PBX.
I don’t understand the question -
Sometimes changes occur with the connection
without you knowing about them. These
changes may cause the connection to fail. Many
failed connections that were originally setup
using the PBX Configuration Wizard can be
repaired by running the Wizard again. The
Wizard detects changes that have occurred
since the last good connection was made.
◆
Is the failed connection a direct cable link or a
modem connection?
Direct Connection
Reasons:
✓
The PC COM Port is currently in use by
another application
✓
Defective cable
✓
Loose cable connection
✓
Incorrect cable type