Filter
Top Products
www.netcomm.com.au Rev.1 - YML632
Page 10 ADSL Modem Router
Chapter 2: Hardware Installation & Setup
This chapter provides information about your NetComm ADSL Modem Router’s physical
features and gives step-by-step installation instructions.
2-1 Rear Panel & Connections
The following figure shows the rear view of the NetComm ADSL Modem Router and illustrates
how the cables connect to the interfaces on the rear panel.
■ Plug one end of the UTP cable into the WAN port, the other into the the other into the wall
jack that is connected to the ADSL service.
■ Connect a computer, with a Network Interface Card installed, to one of the four LAN Ports.
■ Connect the external power supply to the NetComm ADSL Modem Router.
■ Port 4 can cascade to another network device (usually a hub or switch). Make sure the slide
switch is in “X” mode when connecting to an MDI-X port.
■ The Reset button is used to reboot the device - press once quickly, or for clearing
configuration settings back to factory default values - press for longer than 3 seconds.