Filter
Top Products
www.netcomm.com.au Rev.1 - YML632
Page 20 ADSL Modem Router
3-3 Initial Configuration – Setup
The “OnePage Setup” screen is the first screen you will see when you access the router’s
configuration. If the router has already been successfully installed and set up, this screen’s
values will already be properly configured. Below is a description of each setting.
■ Host Name This entry is required by certain ISPs.
■ Domain Name This entry is required by certain ISPs.
■ Private IP Address The Device IP Address and Subnet Mask of the router are used by the
internal LAN. The default values are 192.168.1.1 for IP Address and 255.255.255.0 for
Subnet Mask.
■ VC Setting Enter the VPI and VCI values provided by your ISP. As for the Operation
Mode, this ADSL Switch Router supports “ANSI T1.413”, “G.dmt”, and G.lite. You can
choose one of those modes from the pop-down list if you exactly know which mode your
ISP used. Otherwise, leave it as default setting, “Auto”.
WAN Connection Type
WAN Connection type is the way the ADSL Switch Router works with DSLAM equipped in
your ISP side. This ADSL Switch Router supports seven connection types listed as below:
■ Gateway using LLC Encaps. (Dynamic IP)
■ Gateway using LLC Encaps. (Static IP)
■ Gateway using Classical IP
■ Gateway using PPPoE
■ Gateway using PPPoA
■ Router using Classical IP
■ Modem using LLC Encaps.