Filter
Top Products
Error Log 102
Models 2603, 2621, and 2635 Getting Started Guide 10 • System Configuration
Error Log
The Error Log webpage shows recent configuration errors and provides for the configuration of the Syslog. (See
figure 78.) Two parameters are configurable for the Syslog.
• Syslog Host: enter the IP address of the Syslog (Default = 0.0.0.0)
• Syslog Facility: select the type of syslog facility (Default = disabled)s
Click on the Update button to activate the selected parameters. Default value is a disabled Syslog.
Figure 78. Error Log and Syslog Settings
SNMP Daemon
For remote management from an SNMP capable management station, the IPLink’s SNMP Daemon must be
configured. To identify a specific IPLink, configure the Static Variables which the system administrator may
use for link identification.
The Community Table has three configurable parameters.
• Password: this is the password which the remote management station must use to access the IPLink for
reading/writing the SNMP variables.
• Management IP: the IP address of the management station.
• Access: select either Write or Read. The management station can be authorized to configure the IPLink by
‘writing’ to the SNMP variables or limited to a ‘read’-only function.
To delete an entry, click on the ‘Del’ box and click on the Update button.