Filter
Top Products
8
MOVING CUTTINGHEAD TO THE UP POSITION
1. Pull out the cuttinghead lockpin (A) Fig. 4, and move the cuttinghead (B) to the up position.
2. Fig. 5 illustrates the lockpin (A) pulled out and the cuttinghead (B) in the up position.
A
Fig. 4 Fig. 5
B
A
B
MOVING TABLE TO THE 0° CUT-OFF POSITION
1. Rotate locking knob (A) Fig. 6 counter-clockwise as far as it will go. Depress the lever (B) and rotate the table (C) to the 0°
straight cut-off position, release the lever (B), and tighten the locking knob (A).
2. Fig. 7 illustrates the table (C) in the 0° straight cut-off position.
3. For proper operation and adjustment of the table, refer to sections, “ROTATING TABLE FOR MITER CUTTING”, and
“ADJUSTING SLIDING FIT BETWEEN MOVABLE TABLE AND BASE.”
A
B
C
Fig. 6
C
Fig. 7
1. Attach flat washers to the two 5/16-18 x 3/4” screws (A) Fig. 8. Thread the screws into the holes on left side of the saw
(Figs. 8 & 9).
NOTE: Turn the screws only a few threads for further adjustment.
2. Attach the table extension (B) Figs. 8 and 9 to left side of saw table, making sure that the groove of the table extension
(B) is inside the flat washers (C) Fig. 8.
3. Use a straight edge (C) Fig. 10 to ensure that the extension table (B) is even with the saw table (D). Tighten the two screws
(C) Fig. 9.
ATTACHING EXTENSION TABLE AND FENCE SLIDE
A
B
Fig. 8
Fig. 9
B
C