Filter
Top Products
26
On/Off Switch
The band saw is equipped with a push-button
switch that will accept a safety padlock (not
included). To safeguard your machine from
unauthorized operation and accidental starting
by young children, the use of a padlock is highly
recommended – see Figure 54.
Maintenance
Before doing maintenance,
disconnect machine from electrical supply
by pulling out the plug or switching off the
main switch! Failure to comply may cause
serious injury.
Clean the band saw regularly to remove any
resinous deposits and sawdust. Use a brush,
vacuum or compressed air to blow out excess
dust. (Wear safety goggles while doing this.)
Keep the miter slot in the table free of dust and
debris. Keep the guide bearings clean and free
of resin. Use a commercially available gum and
pitch remover if needed.
Keep the guide post clean; occasionally apply a
light coat of oil.
Oil any pins, shafts, and joints. Do not get oil on
pulleys or belts.
Bearings on the band saw are sealed for life and
do not require attention.
Check that the cleaning brush over the lower
wheel is working properly; adjust if necessary.
Remove any deposits from the band wheels and
tires to avoid vibration and blade breakage.
NOTE: Do not use solvents around tires. If signs
of wear or deformation occur, replace the tires.
The table surface must be kept clean and free of
rust for best results. If rust appears, use a
mixture of household ammonia, a good
commercial detergent and #000 steel wool.
Alternatively, commercial rust removers can be
found at many hardware stores.
Apply a light, protective coating over the table,
such as paste wax. Products in aerosol form are
also available in hardware stores and supply
catalogs. Whatever method is chosen, the
coating should protect the metal and provide a
smooth surface, without staining the wood.
Figure 54