Filter
Top Products
2 – General Description
iSCSI/Gigabit Ethernet Port LEDs
2-12 SN0051102-00 A
S
iSCSI/Gigabit Ethernet Port LEDs
The iSCSI/gigabit Ethernet ports shown in Figure 2-7 are RJ-45 connectors that
provide connection to an Ethernet SAN through a 10/100/1000 Base-T Ethernet
cable. The ports are labeled GE1 and GE2.
These ports have two LEDs – the link status LED (green) and the activity LED
(also green).
The link status LED lights up continuously after the router establishes an
Ethernet connection.
The activity LED lights up when the router sends or receives data over the
connection.
Figure 2-7 Gigabit Ethernet (iSCSI) Ports
Ethernet Port – Management
The Ethernet management port shown in Figure 2-8 is an RJ-45 connector that
provides a connection to a management workstation through a 10/100 Base-T
Ethernet cable. The port is labeled MGMT.
Figure 2-8 Ethernet Management Port
You can use a Windows®, Solaris™, or Linux™ workstation to configure and
manage the router over an Ethernet connection using the SANsurfer Router
Manager, CLI, or simple network management protocol (SNMP).
The management Ethernet port has two LEDs:
The link status LED (green) is on continuously after the router establishes an
Ethernet connection.
The activity LED (green) is on when the router sends or receives data over
the Ethernet connection.