Filter
Top Products
A – Log Messages
Error Log Messages
SN0051102-00 A A-15
A
323 iSCSI Login PDU was received with a TSIH out of range. This would occur if
the iSCSI initiator attempting the login failed to used the TSIH value provided
in the Target Login Response PDU (router is target) in subsequent login PDUs.
324 iSCSI Login PDU was received with an invalid TSIH value. The TSIH is invalid
because there is no session with that TSIH value. This would occur if the
iSCSI initiator attempting the login failed to used the TSIH value provided in
the target login response PDU (router is target) in subsequent login PDUs.
393 CHAP validation failed during login.
394 Unexpected CHAP key.
548 Failed to allocate an object for Set Port Info IOCTL processing:
PortType: 0 = FC, 1 = iSCSI
PortId: 0 = FC1 or iSCSI1(GE1), 1 = FC2 or iSCSI2 (GE2)
666 Inquiry command failed. The Inquiry command was issued by the router as
part of its discovery process.
669 Pass-Through command for Inquiry command for page 83 failed. The Inquiry
command was issued by the router as part of its discovery process.
675 Pass-Through command for Read Capacity command failed. The Read
Capacity command was issued by the router as part of its discovery process.
676 Read Capacity command failed. The Read Capacity command was issued
by the router as part of its discovery process.
736 Pass-Through command issued by management application (such as the
SANsurfer Router Manager) was aborted.
740 Pass-Through command issued by management application (such as the
SANsurfer Router Manager) failed due to invalid CDB length.
741 Pass-Through command issued by management application (such as the
SANsurfer Router Manager) failed due to invalid data length.
757 Pass-Through command issued by management application (such as the
SANsurfer Router Manager) was interrupted or timed out.
790 IOCTL operation unsupported. Operation code provided in log message.
808 Report LUNs command failed. The Report LUNs command was issued by
the router as part of its discovery process.
809 Report LUNs command failed with check condition status. The Report LUNs
command was issued by the router as part of its discovery process.
811 Failed to allocate LUN object: out of resources.