Filter
Top Products
tO know your 'Ointer-manet
I ..... P
HEAD
OF
SQUARE
FENCE \
INFEED
TABLE
::e. Adjust 450 stop in the same manner.
NOTE: Tilt scale will not require adjustment if it
was= adjusted foi _ 90 ° position.
4,
CUTTER GUARD. Provides protection over the
cutter head. It must always be in place and function-
ing properly.
Check the. guard to make sure it iS functioning pro-
perly.
a. Posi.tion fence to right for maximum width of cut.
b. Pass al/4 in. thick piece of wood over cutterhead
between quard and fence.
Guard must return automatically to "rest position"
against fence When free of the wo0d:
If guard'does not return automatically, see Trouble
Shooting and Maintenance Sections.
CUTTER
GUARD
FENCE
INFEED TABLE
_. INFEEDTABLE:MUST ALWAYS BE PARAL-
LEL TO THE OUTFEED TABLE.
If the cut edge or surface of the workpiece is
CROWNED, it is an indication that the OUTWARD
END of the INFEED table is HIGH and must be
adjusted.
CROWNED CUT
INFEED TABLE
"_"-__ END HIGH
..... :, If the cut edge or surface of the workpiece is CON- CONCAVE CUT
: : CAVE, it is an indication that the OUTWARD END
of the INFEED table is LOW and must be adjusted.
_: : :Check the infeed table to determine the: "out of
INFEED TABLE LOW
' 14