Filter
Top Products
toknow: your io nter planer
:':i_:_ : : . ........ ..... :
L0osen foUr:ioCk Screws 2:or: 3 turns with 1/2 in.
Wrench;
LEVELING STUDS
I
LOCKSCREWS
VIEW LOOKING UP FOR PARTS IDENTIFICATION
Turning the' LEVELING STUDS will RAISE or LOWER
the infeed table.
SCREWING in the studs will RAISE the table . . .
UNSCREWING them will LOWER the table.
a, With: a 3/4 in. wrench turn leveling studs until
infeed table is parallel with straightedge.
b; While: holding studs with wrench, TIGHTEN all
four LOCKSCREWS... tighten each screw a little
bit =at _:a time Until all four screws are:::itight;
_. RecheCk with straightedge to make sure infeed
table is parallel to outfeed table.
6. ON-OFF SWITCH: It is unlikely that it wiff be
turne_ "ON" accidentally, when touched or bumped,
because of the way it is shaped.
In an emergency, it can be turned "OFF" by striking
it with the palm of the hand.
The "yellow button" is a key. When inserted in the
switch lever, the power may be turned ON and OFF.
When it is removed, the power cannot be turned ON.
THIS FEATURE IS INTENDED TO PREVENT
UNAUTHORIZED AND POSSIBLE
HAZARDOUS USE BY CHILDREN AND
OTH ERS.
a, Insert Key into switch.
NOTE: Key ismade of yellow plastic.
KEY
16