Filter
Top Products
If the fence does not slide easily along the bars, the pressure
of the spring can be REDUCED,
_. Loosen the screws,_
2., Move spring slightly toward rear of fence .... tighten
screws.
The rip fence must be PARALLEL with the sawbtade
(see page 23) and Miter Gauge grooves .... Move fence
until it is along side of groove. Do NOT LOCK IT tt
shouM be parallel to groove. If it is not;
A,, Loosen the two "Hex,, Head Screws,'"
13. Hold fence head tightly against bar ,, . move end
of fence so that it is parallel with groove.
Co Alternately tighter{ the screws_
\\
HEX SCREWS
F[ NCE_HEAD_
ADJUSTING RIP SCALE INDICATOR
Turn ELEVATION handwheel clockwise until blade is
up as high as it w{If go.,
IMPORTANT: BLADE must be SQUARE (90 ° ) to
TABLE, in order to ALIGN rip fence.
Z Position fence on right side of sawblade so that it
touches the sides of the teeth .... tighten lock knob.
3, Loosen screw holding the indicator _ ,, adjust indicator
so that it points to "0". o •tighten screw°
NOTE: If you cannot ad'lust indicator so that it points
to "0", loosen the screws hofding the front guide bar
and move the guide bar,
LOCK HANDLE"_
INSTALLING BLADE GUARD
1, From amoung the loose parts, find the hardware,.
2, Attach SPREADER to SPREADER SUPPORT so that
screws are all the way back in the SLOTS of SUPPORT
.... hand tighten screws,
THUMB SCREW
SPREADER ROD
SUPPORT
12