Filter
Top Products
10 REMOVING AND INSTALLING SAWBLADE
WARNING: FOR YOUR OWN SAFETY, TURN SWITCH
"OFF" AND REMOVE PLUG FROM POWER SOURCE
QUTLET BEFORE REMOVING OR INSTALLING
SAWBLADEo
A, Remove insert_
B Place ARBOR wrench on fiat surfaces of saw
ARBOR .... ARBOR NUT wrench on nut ,_.
position wrenches as shown ,° hold your hands
well above blade.
C. With ARBOR wrench against table, PULL ARBOR
NUT wrench FOREWARD to LOOSEN nut
D, To TIGHTEN nut ..... HOLD ARBOR wrench
against rear of table .... PUSH ARBOR NUT
wrench toward rear,
NOTE: When installing the blade make sure the
teeth are pointing toward the front of the saw .....
and that the blade and collars are clean, and free
from any burrs
The HOLLOW side of the collars must be against
the blade
Always tighten the arbor nut securely,
To replace insert
Place insert into insert opening in table and push
toward rear of saw to engage spring clip and until
keyslot in insert wilt drop over screw Tighten screw,
Do not tighten screw to the point where it will deflect
the insert
PULL TO LOOSEN
PUSH TO TIGHTEN
FLAT SURFACES COLLAP,
TEETH POINTING
FRONT OF SAW
ARBOR NUT
/
11 EXACTd-CUT
The "yellow" plastic disc imbedded in the table in front
of the sawblade, is provided for marking the location of
the "sawcut" on the workpiece
A Check disc ,_ , if it is above table surface, place a
piece of hardwood on top of it and tap it down,
B, With blade 90 ° (square to table) cut off a piece of
wood
C, Pull miter gauge back until wood is over disc Using
very sharp pencil, mark a line on disc,,
D, With miter gauge in right hand groove, follow same
procedure and mark another line on disc
E These lines indicate the "path" of the cut (kerf)
made by the sawblade,
F, When cutting the workpiece, line up mark on
workpiece with line on disc,
BLADE GUARD NOT SHOWN FOR PICTURE CLARITY
/
16