Filter
Top Products
When "WIDTH OF RIP" is 2 in.. to 6 in. wide USE THE
PUSH STICK to feed the work.
When WIDTH OF RIP is NARROWER than 2 in., the push
stick CANNOT be used because the guard will interfere .
USE the AUXILIARY FENCE/WORK SUPPORT and
PUSH BLOCK.
Attach Auxiliary Fence/Work Support to rip fence with
two "C" clamps..
AUXILIARY FENCE/
WORK SUPPORT
/t I
Feed the workpiece by hand along the AUXILIARY
FENCE/WORK SUPPORT until the end is approx_ 1 in. past
the front edge of the table. Continue to feed using the
PUSH BLOCK.
Hold the workpiece in position and install the PUSH
BLOCK by sliding it on top of the AUXILIARY
FENCE/WORK SUPPORT (This May Raise Guard)
BAFFLE
Narrow strips thicker than the Auxiliary Fence/Work
Support may enter the guard and strike the baffle
CAREFULLY raise guard only enough to clear the
workpiece UsePUSH BLOCK to complete cut,,
PLOUGHING AND MOLDING
PLOUGHING is grooving with the grain the long way of the
workpJece, using the fence USE proper holddowns and
feed devices.
MOLDING is shaping the workpiece with the grain the long
way of the workpiece, using the fence. Use proper
holddowns and feed devices
21