Filter
Top Products
EvENW'TH,AOLE
Figure 58
Figure 59
Hold workpiece against auxiliary fence and feed with left
hand until workpiece is about EVEN with END of table
•.. Stop Feeding. (See figure 57.)
Hold workpiece FIRMLY ... turn AUXILIARY FENCE
over ... (See figure 58.)
Hold workpiece against AUXILIARY FENCE ... feed
with RIGHT Hand ... guide with LEFT hand until clear of
table. (See figure 59).
When ripping thin strips that may enter the guard and strike
the baffle. CAREFULLY raise guard only enough to clear
the workpiece. (See figure 60 and 61.)
RESAWING
RESAWING is known as ripping a piece of wood through
its thickness. To RESAW a piece of wood wider than 2-1/8
inch ... it will be necessary to remove the blade guard ...
and use an AUXI LIARY FENCE which you can make.
Do not attempt to resaw BOWED or WARPED material.
Use a piece of 3/8 inch plywood 9 in. x 20 in.... and
attach a strip of wood 1-5/8 inches thick x 2-1/2 inches
wide. (See figure 62.)
Clamp it to the table so that the workpiece will SLIDE
EASILY but not TILT or MOVE SIDEWAYS without
BIN DI NG between the two fences. (See figure 63.)
BAFFLE
Figure 60
Figure 62
WARNING: FOR YOUR OWN SAFETY ...
1. NEVER RESAW FREEHAND (WITHOUT USING RIP
FENCE AND AUXILIARY FENCE) BECAUSE THE
BLADE COULD BIND IN THE CUT AND CAUSE A
KICKBACK•
2• DO NOT "BACK UP" (REVERSE FEEDING) WHILE
RESAWlNG BECAUSE THIS COULD CAUSE A
KICKBACK.
3. INSTALL BLADE GUARD IMMEDIATELY UPON
COMPLETION OF THE RESAWlNG OPERATION.
WIDER THAN 2-I/8"
DADOI NG
For best results and to avoid excessive load on the motor,
NEVER CUT A 13/16" WIDE DADO, DEEPER THAN
3/4" IN ONE PASS.
21
Figure. 63