Filter
Top Products
assembly and adiustments
SIDE VIEW
4 3 2 1
4 /
SAW TABLE SPACER GUIDE BAR
RACK
LOCKW_
Figure 11
SCREW
/4 - 20 x 21N._
SWITCH BOX
4
Figure 12
5
(2) Attach this assembly to the center hole in the
table and secure the assembly with a 1/4 inch
Iockwasher and I/4-20 inch hex nut. Do not
tighten the nut until all attaching screws are in
position.
(3) Place each rack in position (as shown in figure
11) and insert a 1/4-20 x 2 inch slotted round
head screw through the outside hole, through the
guide bar, spacer and table extension. Secure
with a 1/4 inch Iockwasher and 1/4-20 inch hex
nut. (See figure 10.)
(4) Place switch box in position (either to right hand
or left hand side of saw table as desired). Attach
with two 1/4-20 x 2 inch slotted round head
screws through switch box mounting flange, rack,
guide bar, spacer and table. Secure with two
1/4 inch Iockwashers and 1/4-20 inch hex nuts.
(See figures 10 and 11.)
(5) Complete attachment of opposlte rack with two
more screws, aligned with table in the same
sequence described above. Tighten all screws
securely.
d. Installation of Auxiliary Fence and Extension.
(See figure 12.)
NOTE: This adjustable, auxiliary fence and ex-
tension was designed for use on the left-hand
side of the saw (when facing the saw at oper-
ator's position).
(1) Attach the table extension support (1, figure 12)
to outside edge of left-hand table extension with
two 5/16-18 x 3/4 inch screws (5), 5/16-18 inch
nuts and 5/16 inch Iockwashers in position as
shown in figure 12. Do not tighten the screws fully.
(2) Slide the extension slide rod (2) through each
rod support (3) and through the hole in each end
of the support (I). It will be necessary to slide
these rods from under the table because of the
retaining rings.
(3) Attach the sliding extension (9) to each rod (2)
with a 5/16-18 x 3/4 inch screw (5) and 5/16 inch
Iockwasher in the end of each rod. Do not tighten.
This extension should be positioned as shown in
figure 12.
(4) Move the end of sliding extension in. Level the
sliding extension (9) with the table extension.
Tighten 5/16-18 x 3/4 screws (5) in the extension
slide rods (2). Move sliding extension out and
tighten 5/16-18 x 3/4 screws (5) attaching the
support (1) to the extension. If binding is experi-
enced, tap the rod supports (3) in the proper
direction to relieve interference.
(5) Position an extension clamp (7) over each rod
and through the mating hole in support (1). Secure
each extension clamp with a wing nut (8).
(6) Attach the auxiliary fence (6) with the wing nuts
(8), as shown in figure 12.
e. Adjust the Table Insert. (See figures 13 and 14.)
(1) Pressdown on table insertwith fingers to make
sure it is properly secured in the table opening.
(2) Using a small scale or straightedge, check at