Filter
Top Products
SAFETY INSTRUCTIONS TO OPERATOR
17.
18.
19.
20.
Adjust table inserts flush with, or slightly below, the
table top.
For operations which do not permit the use of a spread-
er, serious consideration should be given to the use of
jigs or fixtures to hold the work so the hands of the op-
erator are removed a safe distance from the point of
operation.
The use of abrasive or cut-off wheels, or wire wheels
can be dangerous and is not recommended. (Abrasive
or cut-off wheels are ,used to saw many different ma-
terials including metals, stone, and glass.)
Objects can be thrown upward toward the operator by
the back of the blade if proper operating procedures
are not followed. ?his usually occurs when a small loose
piece of wood or other object works around to the rear
of the revolving blade. It can usually be avoided by re-
moving all loose pieces from the table immediately
after they are cut off, using a long stick of wood, and
by keeping the guard and spreader in place at all times.
Use extra caution when the guard assembly is removed
for dadoing or molding, and replace the guard as soon
as that operation is completed.
21.
22.
23.
24.
Never perform any operation "freehand." This term
means feeding the stock into the saw blade or other
cutting tool without using the miter gauge, rip fence,
taper jig, or some other device which prevents rotating
or twisting of the workpiece during the operation.
Never turn your saw "ON" before clearing the table
of all objects (tools, scraps of wood, etc.) except the
workpiece and related feed or support devices for the
operation planned.
Safety is a combination of operator common sense and
alertness at all times when the saw isbeing used.
Do not cycle the motor switch on and off rapidly, as this
may cause the saw blade to loosen. In the event this
should ever occur, allow the saw blade to come to a
complete stop and retighten the arbor nut normally, not
excessively.
WARNING: Do not allow familiarity
(gained from frequent use of your saw) to
become commonplace. Always remember
that a careless fraction of a second is suf-
ficient to inflict severe injury.
CONTENTS
Page
Unpacking and Pre-Assembly Instructions .... 4
Power Supply and Motor Data ........... 5
Assembly and Adjustments ................ 6
Operating Controls ....................... 16
Page
Maintenance and Lubrication .............. 17
Proper Operating Procedures .............. 18
Trouble Shooting ........................ 22
Repair Parts ............................ 24
TOOLS NEEDED
_ Square
Screwdriver (medium)
Screwdriver (small) I_ ]J (combination square,
Pencil
Pliers Small steel scale
3/8-1nch wrench
7/16-inch wrench
_ _ 1/2-inch wrench
9/16-1nch wrench
NOTE: An arbor wrench and shaft wrench,
for removing or installing the saw arbor nut,
and all necessary hex-"L" wrenches are sup-
plied with the saw. (Refer to the "'Loose
Parts List.")