Filter
Top Products
14
(1) Grounding
A qualified electrician should perform the grounding work for the following 3 points. (Ground Resistance
less than 500Ω)
●The ELCB grounding terminal
●The bonnet grounding terminal
●The load bonnet terminal
Caution
●In the event you cannot ground, consult with our
authorized distributor or our service section.
(2) Operation Check
1. Turn a tarter switch from STOP to RUN .
2. Set the breaker lever to ON .
3. Push a test button in the breaker.
(The device is normal when ELCB Lamp (Red) turns ON and the lever positions at the middle of
ON and OFF ).
4. Push the reset button.
(The ELCB lamp (red) turns OFF)
5. Push down the breaker lever OFF .
6. Proceed with engine start procedure once returning a starter switch to STOP .
In the event you cannot complete all steps as above, the device is out of order. Consult with our
authorized distributor or our service section.
Reset Button Test Button
ELCB Lamp
ELCB Grounding terminal
Earth lod
Bonnet Grounding terminal