Shindaiwa DGW310MC Welder User Manual


 
37
If the equipment will not be used for more than 2 months, perform the following maintenance and storage
procedure.
1 Remove the battery. (Refer to 6-5. Check Battery
2 Change the engine oil. (Refer to 11. Check & Maintenance
3 Drain the fuel from the fuel tank and the strainer. Refer to 11. Check & Maintenance
4 Clean all the parts, cover the equipment and keep in the clean and dry place.
Caution
Recharge the removed battery once a month.
Danger: Electric Shock
Do not operate the equipment if the equipment or you are wet.
Before performing any equipment check or maintenance, stop the engine.
Caution: Injuries
Before performing any equipment check or maintenance, stop the engine.
Caution: Fire/Burns
Keep the equipment far away form fire.
Do not touch the engine and muffler during operation or immediately after
stopping the equipment for the temperature reaches extremely high.
Follow the guideline below when performing any troubleshooting. If you can
not resolve the problem by the troubleshooting guide, contact our authorized
distributor or our service section to request the repair.
Symptoms Presumable Causes Actions
1. Battery Weak 1. Recharge the Battery
Starter motor will not start
2. Battery Dead 2. Replace the battery
1. Fuel Lever at CLOSE 1. Fuel Lever to CLOSE
2. Insufficient Fuel 2. Replenish fuel
3. Water or contaminants 3. Drain water or Clean
in the fuel Fuel Tank & Strainer
The engine will not start
4. Fuse burnt 4. Repair
13. Troubleshooting