Shindaiwa DGW310MC Welder User Manual


 
31
Danger: Electric Shock/Injuries
Before checking, stop the engine and remove the engine key which to be kept by the person to do.
Do not open the doors during operation or just after, because the cooling fan or driving belts can enwind the
body.
Danger: Burns
Never open a radiator cap during operation or just after operation, because of avoid
burns from hot vapor.
Caution: Fire/Burns
Keep the equipment far away from fire.
Do not touch the engine and muffler during operation or immediately after stopping the equipment, for the
temperature reaches extremely high.
Caution: Injuries to eyes and skin
Battery fluid contains diluted sulfuric acid. Avoid contact with eyes, skin or on clothing.
If the fluid comes in contact, especially with eyes, flush with a lot of Water and contact to a physician
immediately.
Caution: Explosion
Do not use the equipment or charge the battery, in the case the
battery fluid level is lower than LOWER
level.
Battery may emit some combustible gas, so keep it away from fire and sparks.
Caution
Besides pre-check before operation, qualified person only should do check and maintenance.
Our authorized distributor or our service section only should do the job marked in the table.
Use the genuine parts only for replacement.
Use the tray to receive when draining the waste fluids.
Be sure to comply with the regulations when discarding hazardous substances such as oil, fuel, coolant (LLC), filter,
battery, etc.
To protect the environment, never discard the waste fluid to the grounds, the rivers, lakes, the oceans,
etc.
To optimize the use of the equipment, be sure to perform the check and maintenance based on the following
table. Use the hour meter on it as rough standard for operation time
11. Check and Maintenance