Filter
Top Products
-16-
W1770 21" Bandsaw w/Foot Brake
SETUP
The fence rail is installed upside down at the factory.
To install the fence, do these steps:
1. Remove the cap screws holding the rail onto the
table, and remove the rail.
2. Flip the rail over and reinstall it with the cap screws
removed in Step 1 (see Figure 14).
3. Place the fence on the rail (Figure 15) and tighten
it securely with the hand knob. Refer to the instruc-
tions on Page 29 to calibrate the pointer.
Fence
Guide Post Handwheel
Insert the guide post handwheel onto the shaft, and
secure it with the cap screw on the flat of the shaft, as
shown in Figure 16.
Figure 16. Guide post handwheel
installed.
Handle
Figure 15. Installing fence onto rail.
Figure 14. Tightening guard rail cap
screws.