Filter
Top Products
-31-
Df[\cN(/(0&N(/)'D]^%J`eZ\()&('
FG<I8K@FEJ
FG<I8K@FEJ
>\e\iXc
This machine will perform many types of operations
that are beyond the scope of this manual. Many of these
operations can be dangerous or deadly if performed
incorrectly.
The instructions in this section are written with the
understanding that the operator has the necessary
knowledge and skills to operate this machine. @]XkXep
k`d\pflXi\\og\i`\eZ`e^[`]]`Zlck`\jg\i]fid`e^Xep
fg\iXk`fe#jkfglj`e^k_\dXZ_`e\
If you are an inexperienced operator, we strongly
recommend that you read books or trade articles, or seek
training from an experienced Table Saw operator before
performing any unfamiliar operations. 8Yfm\Xcc#pfli
jX]\kpj_flc[Zfd\]`ijk
I<8;Xe[le[\ijkXe[k_`j\ek`i\`ejkilZ$
k`fe dXelXcY\]fi\ lj`e^k_`j dXZ_`e\%
J\i`flj g\ijfeXc `ealip dXp fZZli `]
jX]\kpXe[fg\iXk`feXc`e]fidXk`fe`jefk
le[\ijkff[ Xe[ ]fccfn\[% ;F EFK i`jb
pflijX]\kpYpefki\X[`e^
9Xj`Z:fekifcj
ON/OFF Switch: Starts and stops the motor.
Safety Pin & Chain: When installed (as shown in Figure
35) disables the switch to prevent accidental startup.
=`^li\*,. ON/OFF switch disabled.
Safety
Pin
OFF
Switch
Blade Tilt: To adjust the blade tilt, loosen the blade tilt
lock, turn the blade tilt handwheel to position the blade
at the desired angle, then tighten the lock shown in
Figure 36.
Blade Height: To set the blade height, unlock the blade
height lock, turn the handwheel to set the blade height
approximately
1
⁄4" higher than the workpiece, then
re-tighten the blade height lock.
Fence Lock: After adjusting the fence to the desired
width of cut, lock it in place by firmly pushing the fence
lock down until it stops.
Blade Height
Lock
Blade Tilt
Lock
Blade Height
Handwheel
Blade Tilt
Handwheel
Fence Lock
=`^li\*-%Basic table saw controls.