Filter
Top Products
-65-
Df[\cN(/(0&N(/)'D]^%J`eZ\()&('
J<IM@:<
J<IM@:<
This section covers the most common service adjustments
or procedures that may need to be made during the life
of your machine.
If you require additional machine service not included
in this section, please contact Woodstock International
Technical Support at (360) 734-3482 or send e-mail to:
k\Z_$jlggfik7j_fg]fo%Y`q.
>\e\iXc
The table saw features stop bolts that stop the blade
exactly at 45° and 90° when tilting it with the handwheel.
The tilt scale reads "0" when the blade is 90° to the table.
The stops have been set at the factory and should require
no adjustments, unless you notice that your cuts are not
accurate.
9cX[\K`ckJkfgj
D8B< JLI< k_Xk pfli dXZ_`e\ `j
legcl^^\[ [li`e^ Xcc j\im`Z\ gifZ\$
[li\j @] k_`j nXie`e^ `j `^efi\[# j\i`$
fljg\ijfeXc`ealipdXpfZZli%
KffcjE\\[\[ Hkp
90Square .......................................................1
45° Square .......................................................1
Hex Wrench 3mm ...............................................1
Wrench 10mm ...................................................1
Wrench 13mm ...................................................1
J\kk`e^0'Jkfg9fck
(% DISCONNECT THE SAW FROM POWER!
)% Raise the blade as high as it will go, then tilt it toward
0° until it stops and cannot be tilted any more.
*% Place a 90° square against the table and blade so
it contacts the blade evenly from bottom to top, as
shown in =`^li\0). Make sure a blade tooth does not
obstruct the placement of the square.
— If the blade is 90° to the table, then adjustments
do not need to be made. Make sure the tilt
indicator arrow shown in =`^li\0* points to
the 0° mark on the scale. Adjust the position
by loosening the button head screw, moving the
indicator with your fingers, then tightening the
screw.
— If the blade is not 90° to the table, you will need
to adjust the 90° stop screw. Proceed to the next
step.
=`^li\0)%Checking blade at 90°.
KXYc\
0'JhlXi\
9cX[\
=`^li\0*. Tilt indicator arrow.
Indicator