Filter
Top Products
-43-
Df[\cN(/(0&N(/)'D]^%J`eZ\()&('
FG<I8K@FEJ
9cX[\K`ck9\m\c:lkj
When the blade tilt stop bolts are properly adjusted, as
described on GX^\-,, the blade tilt handwheel allows the
operator to tilt the blade to the left, anywhere between
0° and 45°. This is used most often when cutting bevels
or compound miters. =`^li\,- shows an example of the
blade when tilted to 45°.
=`^li\,-. Blade tilted to 45° for bevel
cutting on a typical table saw.
=`^li\ ,,. Flip stop lock lever.
=c`gJkfg
The flip stop can be positioned anywhere along the top
of the miter fence and secured in place with a lock lever
(see =`^li\,,), the same distance away from the blade
as your desired width of cut.
The flip stop can be used in the down position to make
multiple cuts of the same width. It can be pivoted
(hence the name “flip”) out of the way to allow longer
workpieces to be cut, then pivoted back down to make
additional cuts at the specified cutting width.
Lock Lever