Filter
Top Products
-43-
Df[\cN(/(0&N(/)'D]^%J`eZ\('&('
FG<I8K@FEJ
9cX[\K`ck9\m\c:lkj
When the blade tilt stop bolts are properly adjusted, as
described on GX^\-,, the blade tilt handwheel allows
the operator to tilt the blade to the left, anywhere
between 0° and 45°. This is used most often when cutting
bevels, compound miters or chamfers. =`^li\,- shows an
example of the blade when tilted to 45°.
=`^li\,-. Blade tilted to 45° for bevel
cutting on a typical table saw.
=`^li\ ,,. Flip stop adjustment bolt.
Flip Stop
Adjustment
Bolt
=c`gJkfg
The flip stop can be adjusted anywhere along the slot in
the top of the miter fence (see =`^li\,,), and locked
in place the same distance away from the blade as your
desired width of cut.
In the down position, the flip stop can be used to make
multiple cuts of the same width. It can also be pivoted
(hence the name “flip”) out of the way to allow longer
workpieces to be cut, then pivoted back down to make
additional cuts at the specified cutting width.