Filter
Top Products
-70-
Df[\cN(/(0&N(/)'D]^%J`eZ\('&('
J<IM@:<
=\eZ\8[aljkd\ekj
There are four main adjustments for the fence: (1) square,
(2) height, (3) parallelism, and (4) clamping pressure.
Keep in mind that these adjustments are interconnected
and some trial-and-error may be needed to achieve
satisfactory results.
KffcjE\\[\[ Hkp
Hex Wrench 6mm ...............................................1
Square ............................................................1
Felt-Tipped Marker .............................................1
JhlXi\Xe[?\`^_k
The fence face must be square to the table in order to
produce square cuts. The fence should be adjusted so it
does not drag across the table surface.
KfZ_\Zb&X[aljkk_\]\eZ\_\`^_kXe[jhlXi\e\jjkfk_\
kXYc\#[fk_\j\jk\gj1
(% DISCONNECT THE SAW FROM POWER!
)% Place a square on the table against the face of the
fence (see =`^li\('*) to check if the fence is square
to the table.
— If the fence is square to table, go to Jk\g+.
— If the fence is not square to table, go to Jk\g*.
*% Adjust the set screws (see =`^li\('+) on top of the
fence bracket to ensure the fence face is 90° to the
table, then tighten the knurled lock nuts.
+% Look at the gap between the fence and table top.
— If the gap is approximately
1
⁄16" and even from the
front of the table to the back, then no additional
adjustments are necessary.
— If the gap is uneven, if the fence height is more
than
1
⁄8", or if the fence touches the table, then
continue with Jk\g,.
,% Adjust the fence height with the rear rail foot
until the gap between the table and the fence is
approximately
1
⁄16" and even from the front of the
table to the back. Efk\1 @]k_\]ifek\e[f]k_\
]\eZ\e\\[jkfY\X[aljk\[lgfi[fne#lj\k_\
j\kjZi\nj]ifd=`^li\('+2kliek_\d`e\m\e
`eZi\d\ekjXe[i\Z_\Zbk_\jhlXi\e\jjX]k\inXi[j%
=`^li\('*% Checking if fence is square to
table.
0'JhlXi\
=\eZ\
KXYc\
=`^li\('+% Fence components used to
adjust fence height and squareness to
table.
=\eZ\
9iXZb\k
J\kJZi\nj
CfZbElk
I\XiIX`c
=ffk