Filter
Top Products
10 - RW30 USER MANUAL
Moving engine parts can cause bodily injury.
Before working on the generator, remove the spark plugs or fuel injectors to prevent the motor from ac-
cidentally starting.
Block the ywheel while working on the generator.
Metal and dirt particles can cause injury to the eyes.
Wear safety glasses that also offer lateral protection.
Static Electricity can damage the components on the electric board.
Before manipulating cards or other components, connect an earth wire to the earth terminal.
Use antistatic packing material for storing, moving or transporting PC cards.
Magnetic elds created by high voltage can interfere with the workings of pacemakers.
Pacemaker wearers should keep their distance.
Pacemaker wearers should rst consult their doctor before going near any place where welding
operations are being carried out.
Read the instructions.
Only use original spare parts.
Replace the fuel injectors and the fuel system air bleeder as indicated in the motor instruction manual.
MAKE SURE SPARKS FROM THE ENGINE EXHAUST DO NOT START A FIRE
1. Use an approved spark arrester on the motor exhaust wherever or whenever required – check the
legislation in vigour.
LOW VOLTAGE AND FREQUENCIES can damage electrical equipment such as motors.
1. Switch off or disconnect the equipment before starting or stopping the motor.
EXCESSIVE WEAR can cause EQUIPMENT TO OVERHEAT.
1. Allow time for equipment to cool.
2. Reduce the current or operating cycle before restarting to weld.
3. Respect the rated operating cycle.
SAFETY PRECAUTIONS