Filter
Top Products
20 - RW30 USER MANUAL
Display of the step between each bead, (distance in mm, 1 mm
equals to 0.04 inch) and estimate welding time in minutes.
-Setting can be made up to 3 shapes:
Option to repeat the same shape or change the size and
shape as previously indicated.
During welding:
Torch moves to starting point of the rst bead.
Shows the bead’s number in welding, « xxx », and the to-
tal number of beads of the whole resurfacing of the area,
«yyy».
Torch will moves to retracting point after bead.
Press VALID key to start the next bead.
If VALID key is pressed, you will have to set anew welding
area. (As previously seen).
SPACING : x.xx mm
WELD.TIME : xxmin
SETTING SHAPE X ?
NO - VALID
SETTING SHAPE X ?
YES - VALID
RETURN TORCH TO
INITIAL POINT
WELDING CYCLE
BEAD xxx/yyy
MOVE TORCH
VALID TO START
FOLLOWING BEAD
END LAYER N : 1
LAYER N : 2 - VAL
If RESET key is pressed:
Allow to place the torch in « Parking » position.
If VALID key is pressed, torch will move to « Parking » posi-
tion.
If RESET key is pressed, back to message:
STOP AND RESTART OF WELDING CYCLE
During the welding, in whatever mode you have selected,
stopping the welding cycle is always possible:
Pressing the RESET key will stop the weld cycle.
To restart the welding cycle, press VALID key.
According to what mode you are using, a correction of the
exact positioning of the torch during the stopping can be
done:
-Maximum correction: 1 cm following the 2 axis « X » and «
Z »
To stop the welding cycle, press the RESET key.
ERROR MESSAGES
During the setting of the points, some errors message can
appear:
Set Position O2:
The distance between points Position O1 and Position O2
must be minimum or equal to 30mm on « X » axis. (This mes-
sage will be displayed only if the distance between Position
O1 and Position O2 < 30mm). Note : this distance (30mm
equals to 1.18 inch) is set in the parameters menu.
NEUTRAL POINT ?
TRANSPORT - VALID
HELLO
STOP CYCLE
RESTART CYCLE ?
MIN LEN : 30mm !
LENGTH : xx mm
OPERATION