Filter
Top Products
16 - RW30 USER MANUAL
LANGUAGE SETTING
Different languages may be accessed and selected when
the rst message “HELLO” appears by using the PLUS key.
Translations of the message “HELLO” into different languages
according to geographic areas are then displayed each time
the PLUS key is pressed.
SETTING THE DATE AND TIME
To set the date and time, scroll until “DATE AND TIME” is
displayed. Set the date and time by pressing the PLUS or
MINUS keys. Conrm using the VALID key.
Depending on how the unit is congured, the “DATE TIME”
message may not be displayed if the most succinct level of
operator dialogue is used.
PRINTING DATA
To print the data stored in memory:
1. Make sure that the unit is connected to a power source.
2. Connect either a serial printer (9-pin connector) or a parallel
printer if the unit is equipped with a parallel interface (25-pin
connector).
When using a serial printer, make sure:
1. that the serial printer communication parameters
are set correctly:
• 9600 bauds
• no parity
• 8 data bits
• 1 stop bit
2. that the correct serial cable is used.
3. Make sure the printer is ONLINE and READY.
4. Turn on the unit and scroll to the IMPRESSION step,
available by the automatic detection by the system of the
presence of a printer.
5. Select the output mode:
• Welding number
• Operator ID
• Date
• All
6. Conrm choice using the VALID key.
INFORMATION ON DATA TRACKING
MANUAL DATA ENTRY
Some areas may require manual data entry:
• Operator stamp
• Location, district code, line, mileage point,
track and rail line
• Type of metal deposition
• Type of power source
• Type of rail
• Type of resurfacing.
Two types of manual entries are possible:
1. Character by character mode.
Pressing the PLUS or MINUS keys causes the allowable
characters to be displayed each character is conrmed by
the VALID key.
2. Pre-programmed values.
Pressing the PLUS or MINUS keys causes the various pre-
programmed values to be displayed. Each value is then
conrmed by pressing the VALID key. When the characters
“----” appear, this indicates characters available for manual
character-by-character entry.
AUTOMATIC DATA ENTRY
Data can also be acquired by reading bar codes.
Depending on the software installed in the unit and according
to the user companies’ specications, data may be acquired
automatically. Depending on these specications, data may
be required or optional.
The software includes a standard operator description card
with a 30-digit ISO bar code.
OPERATION