Filter
Top Products
18 - RW30 USER MANUAL
Set point Position O3. The torch cans only moves on the «
Z » axis.
Set point Position O4. This point should only be set vertically
from point Position O1 with automatic tone of this position.
Display the length and the width of the setting shape (1 mm
equals to 0.04 inch).
Surrounding selection: « YES », or « NO », (continuing bead
from Position O1 to Position O2 then to Position O3 then to
Position O4 and nally to Position O1).
Display the number of beads that will be made during the
resurfacing (the surrounding is not included in this number).
It is possible to modify this number if needed by pressing:
PO4
TORCH:
PO4
TORCH:
PO4
TORCH:
or
or
LENGTH: xxmm
WIDTH: xxmm
SURROUND ?
YES - VALID
SURROUND ?
NO - VALID
NUMBER BEADS:
xx
or
SPACING: x.xx mm
WELD.TIME: xxmin
Display of the step between each bead, (distance in mm, 1 mm
equals to 0.04 inch) and estimate welding time in minutes.
Welding mode choice: bead by bead, « YES », or continue,
« NO ».
If « YES », welding bead by bead (Torch is moving at the be-
ginning of the next bead right after previous bead is done).
If « NO », beads are done in “continue”.
If VALID key is pressed, Torch will move to starting point of
Position O1. Welding will start.
While welding:
Torch moves to starting point of the welding or at the beginning
of the new bead if “bead by bead” mode has been selected.
Surrounding welding if that option has been selected.
Shows the bead’s number in welding, « xxx », and the to-
tal number of beads of the whole resurfacing of the area,
«yyy».
If « bead by bead » option is selected, the following screen
appears at the end of the previous bead and after the torch
is set.
BEADS 1 BY 1 ?
NO - VALID
BEADS 1 BY 1 ?
YES - VALID
WELDING CYCLE
VALID
RETURN TORCH TO
INITIAL POINT
WELDING CYCLE
SURROUND
WELDING CYCLE
BEAD xxx/yyy
VALID TO START
FOLLOWING BEAD
OPERATION