Filter
Top Products
RW30 USER MANUAL - 11
PREPARING THE RW30 FOR
OPERATION
CLAW VERSION
1. Position the claw on the rail.
2. Adjust the sliding jaw and tighten.
3. Check the jaw angle and reference supports.
OPERATION
OVERVIEW
The RW30 is an electric arc welding controller to be used for
gas-free sheathed wires. It is unbeatable on railroad worksites
for performing maintenance and repairs on rails and track
devices, railways, tramways, metros, shuttles, etc.
The RW30 after programming automatically executes the
reloading of worn sections and accidental surface defects
(on treads, rail butt joints, lateral wears, track devices), or the
deposits of “safety stainless steel beads”.
The RW30 controls the motorized movement of the welding
head in the X-axis (length) and Y-axis (width) for work over a
surface area of 400 mm by 350 mm.
The RW30 frame is made of composites, aluminum and
stainless steel. This principle of construction was retained
to combine lightweight and excellent behavior under bad
weather conditions.
The RW30 is sold as standard with :
-1 RW30 Frame
-1 Rail Gripping Set
-1 Torch Support for the Pull Gun
-1 Charlie Control Box with its Connecting Cable
Frame
Torch Support
Rack
Adjustment
Tighten
Jaw Angle
Reference
Supports