Filter
Top Products
39
Super Finish 7000
GB
5 SPRAYING TECHNOLOGY
Move the spray gun evenly during the spraying process. If this
is not observed, an irregular spraying appearance will be the
result. Carry out the movement with the arm, not with the
wrist. A parallel distance of approx. 30 cm between the tip and
the surface to be coated should always be observed. The lat-
eral limitation of the spray fan should not to be too distinct.
The edge of spraying should be gradual to facilitate overlap-
ping of the next coat. The spray gun should always be held at
an angle of 90° to the surface to be coated. A spray fan aimed
obliquely at the surface to be coated leads to an unwanted
spray cloud.
Depending on the material, the use of a
smaller nozzle size or fewer guns can impro-
ve the spray pattern when using multiple-
gun operation.
To achieve perfect surfaces at varnishing works, special acces-
sories are available at Wagner, e.g. FineFinish tips or an AirCoat
gun set. Your Wagner dealer will advise you.
6 HANDLING THE HIGHPRESSURE
HOSE
The high-pressure hose is to be handled with care. Avoid sharp
bending or kinking. The smallest bending radius amounts to
about 20 cm.
Do not drive over the high-pressure hose. Protect against
sharp objects and edges.
Danger of injury through leaking high-
pressure hose. Replace any damaged high-
pressure hose immediately.
Never repair defective high-pressure hoses
yourself!
When using the high-pressure hose while
working on scaolding, it is best to always
guide the hose along the outside of the scaf-
folding.
6.1 HIGHPRESSURE HOSE
The unit is equipped with a high-pressure hose specially suit-
ed for diaphragm pumps.
Only use WAGNER original-high-pressure
hoses with internal heating in order to ensure
functionality, safety and durability.
Longer hoses (30 m is optimal) reduce vibra-
tions.
7 INTERRUPTION OF WORK
1. Turn pressure regulating knob three revolutions to the
left.
2 Open relief valve (2)
valve position (circulation)
3. Switch o the unit
4. Pull the trigger guard on all spray guns in order to safe-
ly relieve the pressure of high-pressure hoses and spray
guns.
5. Secure the spray gun, refer to the operating manual of the
spray gun.
6. Remove tip from tip holder and store the tip in a small ves-
sel with suitable cleaning agent.
7. Leave the suction system immersed in the coating mate-
rial or immerse it in the corresponding cleaning agent.
The suction lter and unit should not dry out.
8. Cover the material container in order to prevent the paint
from drying.
When using quick-drying or two-component
coating substances, always ush the device
through with a suitable cleaning agent with-
in the processing time, as otherwise it will be
dicult to clean.
s pr ay Ing techn Ique / h andl Ing the hIgh-pressure hose / Interrupt Ion of work