Filter
Top Products
40
Super Finish 7000
GB
dIspl ays at the unIt / c lean Ing the unIt
8 CLEANING THE UNIT
A clean state is the best method of ensuring operation with-
out problems. After you have nished spraying, clean the unit.
Under no circumstances may coating material rests dry and
harden in the unit. The cleaning agent used for cleaning (only
with a ash point above 21 °C) must be suitable for the coat-
ing material used.
• Securethespraygun, refer to the operating manual of
the spray gun.
Remove and clean the tip and tip guard.
1. Open relief valve
valve position (circulation) and switch on unit
2. Remove suction hose from the material container, the re-
turn tube remains over the material container.
3. Immerse the suction system into a container lled with a
suitable cleaning agent
4. Turn the pressure control valve back in order to set a mini-
mal spraying pressure.
5. Close relief valve,
valve position (spraying)
6. Pull the trigger guard of the spray gun in order to pump the
remaining coating material from the suction hose, high-
pressure hose and the spray gun into an open container
(if appropriate, increase the pressure at the pressure con-
trol valve slowly in order to obtain a higher material ow).
When using multiple-gun operation the trigger guards
must be pulled in succession, in order to increase the
cleaning performance.
The container must be earthed in case of
coating materials which contain solvents.
Caution! Do not pump or spray in container
with small opening (bunghole)!
See safety regulations.
7. Open relief valve
valve position (circulation)
8. Pump suitable cleaning agent in the circuit for several
minutes.
9. Close relief valve,
valve position (spraying)
10. Pump the remaining cleaning agent into an open contain-
er until the pump is empty.
11. Switch o the unit
Warm water improves the cleaning eect in
the case of water-dilutable coating materials.
8.1 CLEANING THE UNIT FROM THE OUTSIDE
First unplug the power plug from the outlet.
Danger of short-circuits caused by water
ingression! Never spray down the unit with
high-pressure or high-pressure steam clean-
ers.
The suction hose is only solvent-resistant to
a limited extent. Do not immerse in solvent,
only wipe.
Wipe down unit externally with a cloth which has been im-
mersed in a suitable cleaning agent.
8.2 SUCTION FILTER
Clean lters always ensure maximum volume,
constant spray pressure and problem-free
functioning of the unit.
Unit with suction system
1. Unscrew the lter (Item 1)
from the suction tube (2).
2. Disassemble lter by ro-
tating the base (3).
3. Clean or replace the lter.
Carry out cleaning with
a hard brush and a corre-
sponding cleaning agent.
8.3 HIGHPRESSURE FILTER
1. Open relief valve
valve position (circulation) - Switch the unit o.
2. Open the high-pressure lter and clean the lter insert. To
do so:
3. Unscrew the lter housing (1) by hand.
4. Remove the lter insert (2) and pull out the bearing spring
(3).
5. Clean all the parts with the corresponding cleaning agent.
If compressed air is available – blow through the lter in-
sert and bearing spring.
6. When mounting the lter ensure that the bearing ring (4)
in the lter insert is positioned correctly and check the O-
ring at the lter housing for damage.
7. Screw on the lter housing by hand until it stops (a higher
tightening force only impedes later dismantling).
1
3
2