Filter
Top Products
Operation 11
MAN0155 (Rev. 2/16/2007)
4. Grease slip joint on driveline.
NOTE: Check gearbox oil level daily after initial
start up.
Figure 3. Lubrication Points
INSTALL 3-POINT PINS
NOTE: Stump grinder includes Category 1 and Cate-
gory 2 hitch pins. Install hitch pins as instructed.
Category 1 Hitch Pin
Install hitch pin on the inside of 3-point attachment
bracket as shown in Figure 4. Secure with lock washer
and hex nut.
Figure 4. Category 1 Hitch Pin Installed (Right Side)
Category 2 Hitch Pin
Install hitch pin on the outside of 3-point attachment
bracket as shown in Figure 5. Secure with lock washer
and hex nut.
Figure 5. Category 2 Hitch Pin Installed (Right Side)
ATTACH STUMP GRINDER TO TRACTOR
NOTICE
■ Top cylinder must be completely raised to
avoid driveline damage before raising 3-point lower
lift arms.
Figure 6. Stump Grinder Attached to Tractor
(Category 1 Hitch Pins Shown)
1. Attach stump grinder hitch pins to tractor 3-point
lower lift arm and secure.
2. Attach tractor top link to stump grinder clevis and
secure with tractor top link pin.
3. Connect driveline to tractor PTO shaft.
4. Slide slip collar back or push slip pin in to make
connection.
5. Make sure connection is secure. Slip collar or slip
pin should snap back into original position.
6. Adjust the tractor 3-point arm anti-sway devices to
prevent stump grinder from swaying side-to-side
during transport.
7. Adjust tractor drawbar so that it will not interfere
with stump grinder or driveline.
DP6
CAT 1 Hitch Pin
DP7
CAT 2 Hitch Pin
DP5