Filter
Top Products
Dealer Check Lists 23
MAN0155 (Rev. 2/16/2007
DEALER CHECK LISTS
PRE-DELIVERY CHECK LIST
DEALER’S RESPONSIBILITY
Inspect stump grinder thoroughly after assembly to
ensure it is set up properly before delivering it to the
customer. The following check list is a reminder of
points to inspect. Check off each item as it is found sat-
isfactory or after corrections are made.
___ Check that shields and guards are properly
installed and in good condition. Replace if dam-
aged.
___ Check all bolts to be sure they are properly
torqued.
___ Gearboxes are not filled at the factory. Prior to
delivery, fill as specified in the Tractor Stability,
page 10 and check to see that there are no leak-
ing seals.
___ Check that all cotter pins and safety pins are
properly installed. Replace if damaged.
___ Check and grease all lubrication points as identi-
fied in Driveline Lubrication, page 14.
DELIVERY CHECK LIST
DEALER’S RESPONSIBILITY
___ Point out the safety decals. Explain their meaning
and the need to keep them in place and in good
condition. Emphasize the increased safety haz-
ards when instructions are not followed.
___ Present Operator's Manual and request that cus-
tomer and all operators read it before operating
equipment. Point out the manual safety rules,
explain their meanings and emphasize the
increased safety hazards that exist when safety
rules are not followed.
___ Show customer how to make adjustments and
properly mount stump grinder to tractor.
___ Show customer how to make sure driveline is
properly installed and that spring-activated lock-
ing pin or collar slides freely and is seated in
groove on tractor PTO shaft.
___ Instruct customer how to lubricate and explain
importance of lubrication.
___ Point out the correct mounting and routing of
hydraulic hoses. Explain that during operation,
mounting, dismounting and storage, care must be
taken to prevent hoses from pulling, twisting and
kinking.