Xantrex Technology 815-3524 Battery Charger User Manual


 
975-0697-01-01 7
This guide for use by qualified personnel only.
Planning Preparations
AC, DC, and Network Components
For a successful installation, you need to plan for AC, DC, and
network components of the power system. The AC and DC
components are described in this section and illustrated in Figure 3
on page 8.
AC components include:
AC Input/AC Output
•AC Loads
AC Disconnect and Over-Current Protection Device
Distribution Panels
•AC Wiring
DC components include:
24-volt Batteries
DC Cabling
DC Disconnects and Over-Current Devices
DC Grounding
Network considerations for Freedom SW only include:
Cables, connectors, network connectors, and terminators for the
SCP and Automatic Generator Start, if installing.
Detailed information on planning and installing your network is
available in the Xanbus System Installation Guide. Refer to the
system guide to determine the type of network layout to install,
as well as guidelines for installing the network. This guide is
available for download at www.xantrex.com
Freedom SW 3K2K 230V InvChg Install Guide.book Page 7 Friday, June 20, 2014 9:11 AM