Filter
Top Products
975-0697-01-01 63
This guide for use by qualified personnel only.
Inverter Drip Shield Installation
The inverter drip shield helps to protect the unit from dripping or
splashing liquids, which causes a shock hazard. The inverter drip
shield is especially useful in marine installations where water from
condensation, rain, or sea may come into contact with the Freedom
SW 230V.
You may purchase the inverter drip shield by contacting an
authorized dealer. When ordering, mention part number 808-9004.
To install the drip shield:
1. Acquire ten #6-3/4 screws needed to fasten the inverter drip
shield to the wall.
2. Locate an appropriate setting for the drip shield above the
Freedom SW 230V making sure you cover the entire width of
the unit.
3. Fasten the screws through the holes in the drip shield into the
wall.
SHOCK HAZARD
Do not operate the unit under wet conditions and when the unit is wet.
This product is intended only for use in dry areas. Installing the inverter
Failure to follow these instructions can result in death or serious
injury.
drip shield may not entirely protect you from this hazard.
Freedom SW 3K2K 230V InvChg Install Guide.book Page 63 Friday, June 20, 2014 9:11 AM