47
Removing the Shipping Screws
To prevent damage during shipping, screws are attached to the TPU to secure its
lamp assembly. You must remove these screws before using the TPU.
To avoid damaging the TPU, make sure you don’t leave either
of the shipping screws in place when you use the unit.
1. Turn the TPU so the glass side
faces up.
2. Use a Phillips (cross head)
screwdriver to remove both
shipping screws from the holes
labeled
CLAMP
, as shown:
3. Install the screws in the storage
holes labeled
STOCK
between
the shipping holes.
Before transporting the scanner, turn it off, remove the TPU, and replace the
shipping screws in the outer holes labeled
CLAMP
. You must also lock the
transportation lock screw on the scanner before transporting it. (See your electronic
EPSON Expression 836XL User’s Guide.
)
If you can’t replace the shipping screws, the TPU’s lamp
assembly may not be in its home position. Reattach the TPU to
the scanner, close the unit, and turn on the scanner. The lamp
assembly returns to its home position. Then turn off the
scanner, remove the TPU, and insert the screws.
storage
holes
