Filter
Top Products
Chapter 4 265
Instrument Functions: P - Z
System
Instrument Functions: P - Z
4.8.5.5 Subnet Mask
Changes the subnet mask of the instrument. The subnet mask is a 32-bit address mask
used in IP networks to indicate the bits of an IP address that are used for the subnet
address. The default address is 255.255.0.0 for a class B network
Key Path: System, Config I/O
State Saved: Survives Preset and power cycle, but not saved in Instrument State.
Factory
Default: 255.255.0.0 (Not reset by
System, Restore Sys Defaults.)
History: Added with firmware revision A.03.00.
Remote Command:
There is no equivalent remote command.
4.8.5.6 Gateway Address
Allows you to set the gateway address. The gateway address feature is used to manipulate
the gateway used to reach the destination. The gateway address can be changed by
entering a numeric address composed of numbers and decimal points. Press
ENTER to
complete the entry.
Key Path:
System, Config I/O
State Saved: Survives Preset and power cycle, but not saved in Instrument State.
Factory
Default: 0.0.0.0 (Not reset by
System, Restore Sys Defaults.)
History: Added with firmware revision A.03.00.
Remote Command:
There is no remote command for this key.
4.8.5.7 SCPI LAN
Displays keys to enable SCPI functionality over LAN. There are a number of different
ways to send SCPI remote commands to the instrument over the LAN. It can be a problem
to have multiple users simultaneously accessing the instrument over the LAN. These keys
allow you to limit that somewhat by disabling the telnet socket and/or SICL capability.
Key Path:
System, Config I/O
Remote Command:
There is no remote command for this key.