Filter
Top Products
Chapter 5 337
One-Button Measurement Functions
Mode Setup (Spectrum Analysis Mode)
One-Button Measurement Functions
Example: RAD:STAN C2000DS
5.3.1.10 NADC
Sets the specific parameters for the selected measurement (located under the
“MEASURE
(Spectrum Analysis Mode)”
key description) appropriate for industry standard NADC.
Channel Power and Intermod TOI measurements are not available when Device (MS) is
selected. All other measurements are available when this radio standard is selected
except: Spectrum Emissions Mask, Harmonic Distortion, Spurious Emissions, and
Multi-Carrier Power.
Key Type: 1 of N menu
Key Path:
Mode Setup, Radio Std
History: Modified with PSA firmware revision A.04.00
Added with PSA firmware revision A.02.00
Remote Command:
Use[:SENSe]:RADio:STANdard[:SELect]
See “Radio Std” on page 333.
Example: RAD:STAN NADC
5.3.1.11 PDC
Sets the specific parameters for the selected measurement (located under the
“MEASURE
(Spectrum Analysis Mode)”
key description) appropriate for industry standard PDC. The
Burst Power measurement is not available when Device (BTS) is selected. The Channel
Power and Intermod TOI measurements are not available when Device (MS) is selected. All
other measurements except Multi-Carrier Power, Harmonic Distortion, Spurious
Emissions and Spectrum Emission Mask measurements are available for this standard.
Key Type: 1 of N menu
Key Path:
Mode Setup, Radio Std
History: Added with PSA firmware revision A.02.00
Remote Command:
Use[:SENSe]:RADio:STANdard[:SELect]
See “Radio Std” on page 333.
Example: RAD:STAN PDC
5.3.1.12 Bluetooth™
Sets the specific parameters for the selected measurement (located under the
“MEASURE
(Spectrum Analysis Mode)”
key description) appropriate for industry standard Bluetooth™.