Filter
Top Products
3-8
Cisco Application Deployment Engine (ADE) 2130 and 2140 Series Appliance Hardware Installation Guide
78-18579-02
Chapter 3 Installing the Cisco ADE 2130 and 2140 Series Appliance
Mounting the Cisco ADE 2130 and 2140 Series Appliance in a 4-Post Rack
Figure 3-5 4-Post Rack-Mount Hardware Kit
Attaching the Inner Slide Rails to the Appliance
To install the Cisco ADE 2130 and 2140 Series appliance into the slide rails:
Step 1 Align the inner slide rail holes with the horizontal holes on the side of the appliance beginning with the
second hole. The release spring on the inner slide rail must point toward the rear of the appliance and
face away from the appliance chassis. (See Figure 3-6.)
Figure 3-6 Aligning the Inner Slide Rail with the Mounting Studs
Step 2
Attach the inner slide rail to the appliance with the 8-32 x 3/8-inch screws.
Table 3-2 4-Post Rack-Mount Hardware Kit
Item No. Description Quantity
1 Rack screw, 10-32 x 1/2-inch (1.27 cm) 12
2 Screw, 8-32 x 3/8-inch (.95 cm) 8
3 Nut bar
1
1. Nut bar used in unthreaded round-hole racks or used over the cage nuts for
square-hole racks.
4
4 Cage nut, 10-32 x 3/8-inch (.95 cm)
2
2. Cage nuts are used only when mounting in square-hole racks.
12
— Screw, 6-32 x 1/4-inch (.63 cm)
3
3. Not shown in Figure 3-5. Depending on rack type, can be used in place of 8-32 x
3/8-inch screws.
8
203370
1 2 4
3
231555