Filter
Top Products
4-11
Cisco Application Deployment Engine (ADE) 2130 and 2140 Series Appliance Hardware Installation Guide
78-18579-02
Chapter 4 Installing the Cisco ADE 2130 and 2140 Series Appliance Hardware Options
Installing and Removing Memory
Installing DIMMs
To install the DIMMs:
Step 1 Review the information in the “Safety Warnings” section on page x and the “Safety Guidelines” section
on page 2-2.
Step 2 Power down the appliance and all external devices. Disconnect the AC power cord or DC power source
and all external cables.
Step 3 Attach the antistatic wrist strap to your wrist and connect its cord to the ESD socket on the top, left-hand
side on the front of the appliance.
Step 4 Remove the appliance cover. For instructions, see the “Removing the Cover” section on page 4-3.
Step 5 Locate the DIMM slots. (See Figure 4-6.)
Figure 4-6 Installing DIMMs
1 Ejector tab (open) 4 Ejector tab (closed)
2 DIMM notch 5 DIMM outside connector edge
3 DIMM top connector edge
E
A
C
D
B
DIMM A1
DIMM A2
DIMM B1
DIMM B2
DIMM D2
DIMM D1
DIMM C2
DIMM C1
Branch
0
Branch
1
1
2
3
4
5
231203