Filter
Top Products
4-3
Cisco Application Deployment Engine (ADE) 2130 and 2140 Series Appliance Hardware Installation Guide
78-18579-02
Chapter 4 Installing the Cisco ADE 2130 and 2140 Series Appliance Hardware Options
Tools and Supplies Needed
Tools and Supplies Needed
You need the following tools and equipment to install, replace, and remove the hardware options:
• Number 1 and 2 Phillips screwdrivers
• ESD or antistatic wrist strap and conductive foam pad or mat (recommended)
Beginning the Installation
To begin the installation, you must remove the front bezel and appliance top cover. Before removing the
cover, power down the appliance, and unplug all external cables and the AC power cable or DC power
wires.
Removing the Cover
Warning
Before performing any of the following procedures, ensure that power is removed from the DC circuit.
Statement 1003
Warning
Before working on a chassis or working near power supplies, unplug the power cord on AC units.
Statement 246
Note A nonskid surface or a stop behind the appliance may be needed to prevent the appliance from sliding
on your work surface.
To remove the cover:
Step 1 Review the information in the “Safety Warnings” section on page x and the “Safety Guidelines” section
on page 2-2.
Cisco ADE Accelerator Card – 10 Gb/s (requires
10-Gb small form factor pluggable module [XFP] and
memory)
CADE-EXP-NXN2FG=
Cisco ADE XFP – long reach CADE-XO-NX10GSLR1=
Cisco ADE XFP – short reach CADE-XO-NX10GMLR1=
Cisco ADE – 2-GB onboard memory for 10-GigE card CADE-XO-NRDR22GB1=
1. Serial ATA = Serial Advanced Technology Attachment.
2. SAS = Serial Attached SCSI (Small Computer System Interface).
Table 4-1 Cisco ADE 2130 and 2140 Series Appliance Hardware Options (continued)
Description Cisco Spare Part Number