Filter
Top Products
INSTALLING THE YOKE ASSEMBLY
See Figures 12A - 12C.
The yoke rides in the carriage below the arm and
supports the motor, the blade guard, and the blade.
Install the yoke assembly from the front of the arm.
• Remove the carriage stop screw and Iockwasher
from below the front of the arm with a 1/4 in. hex
key. See Figure 12A.
ARMVIEWEDFROMBELOW
FORCLARITY,CARRIAGECOVERSANDCARRIAGELOCK
KNOBARENOTSHOWNINILLUSTRATION
ARMLOCKKNOB
BEARINGS(4)
CARRIAGE
CARRIAGESTOPSCREW
1/4in.HEXKEY Fig. 12A
• Remove the arm cap screws and arm cap from the
front of the arm with a phillips screwdriver. See
Figure 12B
ARMLOCKKNOB
ARMCAP _
_ARM
CAPSCREWS
Fig. 12B
• Remove and discard the two motor setscrews in
the bottom of the motor. They are for shipping
purposes only.
• Using the elevating handwheel, raise the arm 3
inches and remove the packing material.
• Lock the arm with the arm lock knob, located on top
of the front of the arm, so the arm doesn't swing
while you are mounting the yoke assembly.
• Pick up the yoke assembly and carefully slip it onto
the carriage track below the arm. Keep it parallel
with the arm so bearings slide in smoothly. See
Figure 12C.
YOKE
CARRIAGE ARM
LOCKKNOB
CARRIAGECOVER Fig. 12C
Reinstall the carriage stop screw, the Iockwasher,
arm cap, and arm cap screws. Tighten all screws
securely.
,t_ WARNING: Once the yoke assembly is on the
carriage track, reinstall the arm cap, the arm cap
screws, the carriage stop screw, and the
Iockwasher. Do not risk serious injury or damage
to the saw by failing to replace these parts.
• Tighten the carriage lock knob, on the carriage
cover on the left of the arm, to lock the yoke
assembly in place.
I:RI_FT=_MRN_RADIALSAW 315.273731 22