Filter
Top Products
NON-THROUGH CUTS
See Figure 48.
,_ WARNING: Unplug the saw while removing or
replacing the blade guard. Turn on the saw with
the switch on the arm to confirm the blade is not
receiving power.
• Remove the blade and blade guard (see Assembly
section).
• Place a support the same height as the saw table
nearby for the cut work. Lower the blade with the
elevating handwheel.
• Make sure the wood is not touching the blade.
Insert the key and turn on the saw. Let the blade
build up to full speed before contacting the work-
piece.
,_ WARNING: Always use pushblocks when
making non-through rip cuts to avoid the risk of
serious injury. Never feed wood with your hands.
• When the work is completed, press the switch off
and remove the key.
NON-THROUGHCUT
Fig. 48
ControlCut Settings
Crosscut
Wood Setting Feet
Type Position Minute
Hard A 0-6
Medium B 0-20
Soft C 0-35
Bevel Crosscut
Wood Setting Feet
Type Position Minute
All Types A 0-6
Miter Crosscut
Wood Setting Feet
Type Position Minute
Hard A 0=6
Medium B 0-20
Soft C 0-35
Corn}oundCrosscut
Wood Setting Feet
Type Position Minute
AiJTypes A 0=6
51 CR_FTSHRN°RADIALSAW315.273731