Filter
Top Products
D
IGITAL CONTROL INCORPORATED
®
Safety Precautions
and Warnings
Important Note: All operators must read and understand the following Safety
Precautions and Warnings before using the DigiTrak Locating System.
1 Serious injury and death can result if underground drilling equipment makes contact
with an underground utility such as a high-voltage electrical cable or a natural gas
line.
) Substantial property damage and liability can result if underground drilling equipment
makes contact with an underground utility such as a telephone, fiber-optic, water, or
sewer line.
) Work slowdown and cost overruns can occur if drilling operators do not use the
drilling or locating equipment correctly to obtain proper performance.
¾ Directional drilling operators MUST at all times:
•
•
•
•
•
•
Understand the safe and proper operation of drilling and locating equipment, including the
use of ground mats and proper grounding procedures.
Ensure that all underground utilities have been located, exposed, and marked accurately
prior to drilling.
Wear protective safety clothing such as dielectric boots, gloves, hard-hats, high-visibility
vests and safety glasses.
Locate and track the drill head accurately and correctly during drilling.
Comply with state and local governmental regulations (e.g., OSHA).
Follow all other safety procedures.
¾ The DigiTrak System cannot be used to locate utilities.
¾ Continued exposure to heat, due to frictional heating of the drill head from drilling in sand, gravel,
or rock without sufficient fluid flow around the Transmitter, can cause inaccurate depth to be
displayed and may permanently damage the Transmitter. For more information see “Tempera-
ture Overheat” in the Transmitter Section.
) The DigiTrak equipment is not explosion-proof and should never be used near
flammable or explosive substances.
vi DigiTrak
®
Mark III Operator’s Manual